Uniden BCD996T User Manual
Page 89
89
Programming Your Scanner
Auto — the scanner uses the default modulation for the channel. The default
setting is Auto.
AM — the scanner uses AM (amplitude modulation) for the channel.
FM — the scanner uses FM (frequency modulation) for the channel.
NFM — the scanner uses narrowband FM for the channel.
WFM — the scanner uses wideband FM for the channel.
WFM (Broadcast) — the scanner uses FM Broadcast for the channel.
This setting controls the modulation method used for the channel. In most cases, if
you leave this set to Auto, the scanner automatically selects the correct
modulation type for the channel you are programming.
[MENU]
Program System
F
Select a conventional system
F
Edit Group (existing site)
F
Select a channel group
F
Edit Channel
F
Select a channel
F
Set Attenuator
F
This setting controls whether the scanner attenuates signals on this channel.
Select your setting, then press
F
.
On — the channel is attenuated by about 20 dB.
Off — the channel is not attenuated. The default setting is Off.
You can also toggle this setting by holding on the channel and pressing
F
then [7]
within 2 seconds.
[MENU]
Program System
F
Select a conventional system
F
Edit Group
F
Select a channel group
F
Edit Channel
F
Select the channel
F
Set Priority
F
Setting Channel Attenuation
C
Setting Channel Priority
C