VTech DECT 6.0 LS6375-3 - Manual (Page 62)

58
Appendix
handset display screen messages
No line
There is no telephone line connected.
No message
There are no messages in the answering system.
No signal,
call ended
Communication between the handset and
telephone base is lost during a call.
Not available
at this time
One handset is already viewing the call log or
directory and another handset attempts to review it.
Out of range OR
No pwr at base
The handset cannot communicate with the
telephone base. Check the telephone base power
connection or move closer.
** Paging **
The system handset is being paged.
Phone
The handset is on a call.
Place in
charger
The battery is very low. Place the handset in the
telephone base or charger for recharging.
Rec mem full
The answering system has no recording time left.
Rec mem low
The answering system has less than three minutes
of recording time left.
Ringer mute
The ringer is muted temporarily during an incoming
or intercom call.
Saved
Your selection has been saved.
Speaker
The handset speakerphone is in use.
Unable to call.
Try again
You have attempted to make an intercom call, but
the handset you are calling is in the directory, in the
call log or out of range, or the handset or headset
you are calling is on an outside call.
Unable to save
You are attempting to save a caller ID entry without
a name and number.
XX Missed calls
There are calls that have not been reviewed in your
call log.
XX New messages
There are new messages in the answering system.