VTech DECT 6.0 LS6375-3 - Manual (Page 68)

64
Appendix
Add and register a headset (optional)
This telephone system accommodates one headset only. If you want to
replace the registered headset with a new one, you must deregister the
registered headset first (see page 65).
To register a headset:
Place the non-registered headset in the headset charger and allow it to
charge for at least 15 minutes before beginning registration. Remove the
headset from the headset charger. The light on the headset flashes
slowly and alternately in red and blue.
On the telephone base of the cordless telephone, press and hold
/FIND hANDSET for about four seconds until the red IN USE light
turns on.
Immediately place the headset in the headset charger. It takes about
60 seconds to complete the registration. The red IN USE light on the
telephone base turns off. The light on the headset turns red when it is
registered but not fully charged, or turns blue if it is registered and fully
charged.
If the registration process is successful, you hear a dial tone when you press
on the headset. If the registration fails, you hear “ Not registered ” through
the headset earpiece when you press on the headset. The light on the
headset flashes slowly and alternately in red and blue. To reset the headset,
remove it from the headset charger and then place it back into its charger. Try
the registration process again.
1.
2.
3.
You cannot register a headset if any other system handset or headset is
in use.
The headset must be deregistered before registering it to another telephone
system.
•
•