VTech DECT 6.0 LS6375-3 - Manual (Page 7)

Getting started
3
Installation options
Your telephone base is ready for tabletop use. If you want to mount your
telephone on a wall, use the provided wall mount bracket to connect with a
standard dual-stud telephone wall mounting plate. If you do not have this
mounting plate, you can purchase one from many hardware or consumer
electronics retailers. You may need a professional to install the mounting plate.
Tabletop to wall mount installation
Plug one end of the telephone line cord into the TEL LINE jack at the
bottom of the telephone base. Plug the small end of the power adapter into
the POWER jack at the bottom of the telephone base.
Position the telephone base as shown below. Insert the extended tabs
marked B of the wall mount bracket into the slots marked B on the back of
the telephone base. Push the telephone base down until it clicks securely in
place.
Route the telephone line cord through the wall mount bracket hole and plug
it into the telephone wall jack. Route the power cord out of the bottom of the
telephone and plug it into an electrical outlet not controlled by a wall switch.
Align the holes on the bracket with the standard wall plate and slide the
bracket down until it locks securely. Bundle the telephone line cord and
power adapter cord neatly with twist ties.
1.
2.
3.
4.
2
4 3
1