VTech 912 - Manual (Page 10)

10
1. Choose a spot near an electrical
outlet and a telephone jack. Your
p h o n e r e q u i r e s a m o d u l a r
telephone jack and a standard
electrical outlet (120v AC). The
power cord is six feet long; make
sure there is an electrical outlet
within reach of the base. The
outlet should not be controlled by
a wall switch. If the switch is ever
turned off, the phone will not
operate.
2. Position the wall mount adapter
on the base. Line up the tabs on
the wall mount adapter with the
holes on the bottom of the base.
Snap the wall mount adapter firmly
in place.
WALL MOUNTING
AND TELEPHONE JACK.
CHOOSE A SPOT NEAR
WALL MOUNTING:
THE ELECTRICAL OUTLET
JACK
TELEPHONE
DEL
AC
OUT LET
WHEN
PAGE
POWER
BATT
IN USE
SPARE CHARGING NEW CALL
MHz CALLER ID 900 912ADLc
woodenstu
PULSE
TONE
INSERT WALL
MOUNT INTO
THE BASE UNIT
SNAP IN FIRMLY
3. Mount the base on the wall.
Position the base so the mounting
studs will fit into the holes on the
bottom of the base. Position the
power cord to extend down the wall
the phone is to be mounted on.
Slide the base down on the mount-
ing studs until it locks into place.
4. Connect the telephone cord.
The telephone line cord has a
snap-in plug at each end. Insert
one of the plugs into the jack on
the bottom of the base. Insert the
other end of the plug into the wall
jack.
PUSH IN
SLIDE DOWN
and
TELEPHONE
WALL
JACK AC
ELECTRICAL
OUTLET
9VDC TEL.LINE