VTech 912 - Manual (Page 8)

8
5. C H A R G E T H E H A N D S E T
BATTERIES BEFORE USE. The
batteries recharge automatically
whenever the handset is in the
base unit cradle. The batteries
must be charged for 24 hours
before using your phone for the
first time. After the initial charge, a
maintenance charge of 8 hours is
sufficient to return a low battery to
full condition.
6. CHECK FOR A DIAL TONE. After
the batteries are charged, pick up
the handset and press the PHONE
key. The IN USE indicator should
light up, and you should hear a dial
tone. If not, see IN CASE OF
DIFFICULTY.
Setting Up Your VTech 912 ADLc
1. Choose an area near an electrical
outlet and a telephone wall jack.
2. Connect the telephone line cord.
Insert one end of the telephone line
cord into the jack at the rear of the
base unit. Plug the other end into
a telephone wall jack. Make sure
the plugs snap securely into place.
.
3. Plug the AC power adapter into an
electrical outlet and the DC
connector to the back of the base
unit.
CAUTION: Use only the AC adapter
shipped with your 912 ADLc. This is a
Class 2 AC adapter, specifically
designed for use with the 912 ADLc.
NOTE: Connect power to the base unit
before placing the handset in the
cradle.
4. Set the TONE/PULSE switch on
the base unit. If you have touch
tone service on your phone line,
set the switch to TONE. If you
have rotary service, set the switch
to PULSE.
GETTING STARTED
TELEPHONE
WALL
JACK AC
ELECTRICAL
OUTLET
9VDC TEL.LINE
VTECH 912ADLc
YOUR
SETTING UP
PULSE
TONE
TONE PULSE
SELECTION