Vivotek IP7138 - Manual (Page 64)

Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition LED color
Loading system after power on Steady green and blink red (once)
During booting procedure Steady green
Detecting and setting network Steady orange (green + red) till IP address
is confirmed
After network is setup (system up) Blink green / orange every second and
steady red
During the upgrade firmware process Blink green / orange every second and fast
blink red
Reset and restore
There is a button in the back of the Network Camera. It is used to reset the system or
restore the factory default settings. Sometimes resetting the system sets the system
back to normal state. If the system problems remain after reset, restore the factory
settings and install again.
RESET: Click on the button.
RESTORE:
63 - User's Manual
VIVOTEK - A Leading Provider of Multimedia Communication Solutions