VTech Cordless Telephone - Manual (Page 10)

10
Getting Started
Installation
Your t 2450 base unit is designed to mount on a standard telephone wall plate.
Wall mounting is optional.
1. Open the hinged wall mount bracket on the underside of the base, then
swivel it down and lock it into place as shown in the diagram above.
2. Run the power and telephone cords through the slot, then connect them to
the jacks located on the underside of the base.
3. Plug the AC adapter into an electrical outlet. If the battery has not been
previously charged, place the handset in the base, and allow it to charge for
15 hours (or overnight). Connect the telephone line cord to the wall jack.
4. Mount the base on the wall. Position the base unit so the mounting studs will
fit into the holes on the wall mount bracket. Slide the base unit down on the
mounting studs until it locks into place.
3
2 1
91-000171-030-000 manual.pmd 11/1/2005, 12:46 PM 10