VTech Cordless Telephone - Manual (Page 15)

15
Basic Operation
You can store up to nine telephone numbers with names (up to 15 characters, 24 digits
each location) you dial frequently into the speed dial memory locations you assign (1-9)
in each handset. These numbers can be dialed only by pressing two buttons.
You can also store telephone numbers with names alphabetically in the direc-
tory. See Telephone Directory for instructions.
NOTES: 1. The entries you store in speed dial memory will be marked with 01
through 09 and also stored in the directory.
2. Press OFF at any time to exit the Speed Dial memory.
Store a Number/Name in Memory:
1. Press PROG. Then press until the screen displays SPEED DIAL.
2. Press SELECT. The screen displays ENTER 1-9.
3. Press the key (1-9) to assign the memory location where this number will be
stored. The screen displays ENTER NAME.
NOTE: Your new entry will be stored in place of the old and will delete the former
entry. Take caution to not save over entries you do not wish to delete from
memory.
4. Using the chart below, enter up to 15 characters for the name you’re storing.
Use to backspace and make corrections; use to add a space.
Telephone Memory
5. When you finish entering the name, press SELECT or PROG. The screen displays
ENTER NUMBER.
6. Enter the telephone number. Use to backspace and make corrections.
Press REDIAL/PAUSE to add pause if necessary.
1: 1
2: A B C 2
3: D E F 3
4: G H I 4
5: J K L 5
6: M N O 6
7: P Q R S 7
8: T U V 8
9: W X Y Z 9
0: 0
*: *
#: & ’ , - . #
Presses
Dial Key 1 2 3 4 5 6
91-000171-030-000 manual.pmd 11/1/2005, 12:46 PM 15