VTech Cordless Telephone - Manual (Page 26)

26
Basic Operation
“Set Audible Message Alert ” When message alert is turned on, the base beeps
Off
* once every 10 seconds when new messages
On have been received.
“Set Announce Only” When you turn Announce Only On, callers hear
Off * your announcement, but cannot leave a message.
On
“Set Base Ringer” Turn the base ringer on or off.
On *
Off
“Set Number of Rings” Choose how many times the phone will ring
2 before the system answers a call.
4 * With toll saver active, the system answers after two
6 rings when you have new messages and after
Toll Saver four rings when you have no new messages.
NOTES:
1. To advance the remote access code by increments of 10, press and hold
CHANGE.
2. You can exit feature setup at any time by pressing a MAILBOX button.
Setting Up Your Answering System
You can set up one feature at a time, or you can set up a feature and then move
on to set up another feature.
1. Make sure the answering system is ON.
2. Press MENU until the system announces the feature you want to set.
Refer to the Feature Summary below for a description of the features and
your choices.
3. Press CHANGE until the system announces the desired setting.
4. Press TIME/SET to confirm your selection.
5. Press MENU to move on to the next feature, or press a MAILBOX button to
exit Feature Setup.
Feature Summary
Default settings indicated by * .
System announces: Description/directions:
“Set Security Code” Use CHANGE to choose the remote access code
you will use to access features and functions of the
answering system from a touch tone phone. You can
select any two digit code, from 40 to 99.
System announces: Description/directions:
Answering System Operation
50 *
91-000171-030-000 manual.pmd 11/1/2005, 12:46 PM 26