Varec 4000 - Manual (Page 29)

19
4000 Configuration
4 Only displayed if host interface type is Mark/Space
5 Only displayed if host interface type is Modbus
6 Only displayed if host interface type is Modbus or Mark/Space
7 Only displayed if there is no temperature sensor
3.5 Quick Setup
The Quick Setup option is meant to get the ATT configured quickly and with some defaults. It is NOT likely that this
configuration will match your installation exactly. However, after the Quick Setup option is selected, you can go
through the 1200 Hand Held Terminal menus to see and modify any parameter. Quick Setup simply gives you a starting
point.
Warning! The Quick Setup option erases all previous configurations in the ATT's EEPROM. If you use the quick setup command
from the 1200 Hand Held Terminal and you change your mind, simply exit the 1200 Hand Held Terminal Main Menu
using the QUIT command. This works since no configuration is changed or used unless the EXIT AND SAVE
command is executed from the Main Menu.
Please note that Quick Setup also configures all alarm setpoints to such values as not to generate alarms. You must
modify the alarm setpoints to match your tank dimensions and your product.
The quick setup default configurations are:
•
Imperial fractional 1800
•
Imperial decimal 1800
•
0-20 meters 1800
•
0-30 meters 1800
•
Imperial fractional 1900
•
Imperial decimal 1900
•
0-20 meters 1900
•
0-30 meters 1900
•
Imperial Modbus
•
Metric Modbus
•
Matrix 1600 Metric
•
Matrix 1600 Imperial
•
Matrix 1700 Metric
•
Matrix 1700 Imperial
•
Matrix 1700 Metric0-20 meters
•
Matrix 1700 Imperial 0-30 meters
•
Matrix 2400 Metric 0-20 meters
•
Matrix 2400 Imperial 0-30 meters
•
LNJ Metric
•
LNJ Imperial
•
Whessoe Bus Matrix
•
Whessoe Bus Imperial
•
GSI Modbus integer scaled
•
GPE loop