VTech 1930c - Manual (Page 32)

30
FLASH
PAUSE
2 3
6
7 9
# 0
MEM/PGM
*
5
1
4
8
HOLD
OFF PHONE
CID REDIAL
INT.COM CLR/DEL MUTE
abc
mno jkl ghi
pqrs tuv wxyz
tone oper
STORING SPEED DIAL
NUMBERS
DIAL YOUR PHONE
NUMBER
PRESS
PRESS LOCATION
(00..20)
PHONE
MEM/PGM
MEMORY DIALING
Storing Memory (Speed) Dial
numbers
To program a speed dial location, do
the following:
¥ With the Handset OFF, enter the
telephone number you wish to
store (20 Digits Maximum).
¥ Enter program mode by pressing
and holding MEM/PGM . The
display will show the following:
¥ Enter the memory location (00..20)
you wish to store the number in.
After the second memory location
digit is entered, the unit will emit a
warbled tone (a short series of
beeps) to confirm successful
programming and exit program
mode.
If programming is unsuccessful the
unit will display:
Unsuccessful programming can result
from not correctly completing the
programming sequence. If this
message appears, simply repeat the
programming sequence.
¥ The number stored in memory
location 00 can be accessed by
pressing the one touch speed dial
Q.MEM key on the Base Unit.
Dialing From Memory
From the Handset
¥ Press PHONE to get a line.
¥ Press MEM/PGM ; you're prompted
to enter a speed dial location
number:
¥ Enter a 2 digit location number
(00..20).
¥ The number stored in that location
will be displayed and immediately
dialed.
Or
¥ Beginning from the OFF mode,
press MEM/PGM followed by a
2 digit location number (00..20).