VTech 1930c - Manual (Page 33)

31
MEMORY DIALING
¥ Press MEM/PGM again to exit
memory dial mode and leave the
number on the display.
¥ Press PHONE . The number on
the display will be dialed after a 2
second pause.
¥ Note that if digits were on the
display prior to entering memory
dial mode, the contents of the
speed dial memory will be
appended to those digits. For
example, if 1503 was on the
display and the contents of the
memory location is 6438981, then
the display would show the
following upon exiting memory dial
mode:
¥ Press OFF to exit.
NOTE:
Stored numbers are retained in memory
even if the base loses its power or the
handset battery is removed.
Storing Special Codes
To insert a pause in a phone number,
press HOLD at the appropriate point
when entering the number . This
inserts a 2 second pause. A " P "
appears in the display to show the
pause. For longer pauses, press HOLD
two or more times. Each press makes
the pause 2 seconds longer and is
treated as a stored digit.
If your phone is connected to a PBX,
you can store the PBX access number
and a pause before the phone
number. For example, to store 9-
PAUSE-555-1234 in memory location
08, do the following:
1. Press 9
2. Press HOLD
3. Dial 5551234
4. Press and hold MEM/PGM
5. Enter 08
Changing Stored Numbers
To change or replace a stored number
simply enter the new number on the
display and store it in the memory
location you wish to change.
Deleting Stored Numbers
¥ Press MEM/PGM . The display will
change to "SPEED DIAL
LOCATION_ _".
¥ Enter memory location number
(00..20).
¥ Press CLR/DEL key. The display
will change to "LOCATION XX
DELETED".