Welch Allyn IMAGETEAM 3800 - Manual (Page 16)

IMAGETEAM 3800 User’s Guide 2–2
Terminal ID
If your interface is not a standard PC AT, refer to the Supported Terminals Chart
on page 2–3 and locate the Terminal ID number for your PC. Scan the
Terminal ID bar code below, then scan the numeric bar code(s) on the inside
back cover of this manual to program the scanner for your terminal ID. Scan
Save to save your selection.
For example, an IBM PS/2 terminal has a Terminal ID of 002. You would scan
the Terminal ID bar code, then 0, 0, 2 from the inside back cover, then Save. If
you make an error while scanning the digits (before scanning Save), scan the
Discard code on the back cover, scan the Terminal ID bar code, scan the
digits, and the Save code again.
Terminal ID
Save
Note:
After you scan one of the codes, power cycle the host terminal to have
the interface in effect