Yamaha PSR-510 - Manual (Page 11)

9
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
2-2: The [
+
] and [
−
] Buttons The [
+
] and [
−
] buttons immediately to the right of the MULTI DIS-
PLAY can be used to increment (increase by one) or decrement (decrease
by one) the currently selected parameter. Press the [
+
] button briefly to in-
crement the parameter value, or the [
−
] button to decrement. If you hold the
[
+
] or [
−
] button down, the value will increment or decrement continuously
— simply release the button when the desired value has been reached.
RESET
– +
The number buttons — to the right of the [
+
] and [
−
] buttons — allow
direct numeric entry of the desired value, and are therefore the fastest way
to edit in many situations.
To select a voice, for example, choose one of the 128 voices — num-
bered “01” through “128” — shown on the panel VOICE list, then enter its
number using the number buttons. To select “HARMONICA” (number 23),
for example, first press [2] then [3]. The number “23” should then appear
on the MULTI DISPLAY.
The [
+
/
−
] button is used to switch between positive and negative values
with parameters that allow negative values (Transpose, Tuning, Octave, and
Pan, for example). A “
−
” appears before negative values on the MULTI
DISPLAY.
When selecting voice numbers the [
+
/
−
] button is used to enter the hun-
dreds digit of the voice number (the button alternately selects no hundreds
digit or “1”), as required, prior to entering the tens and ones digits. The [1]
number button cannot be used to enter the hundreds digit when selecting
voices.
Values outside the range of the selected parameter can not be entered.
2-3: The Number Buttons
0 2 3 4 1
9
+–
1_ _
2-4: The Data Dial
This is undoubtedly the easiest way to edit most parameters. Simply ro-
tate the dial clockwise to increment or counter-clockwise to decrement.
● Yes/No Confirmation Some operations that change important settings or erase data may require you
to confirm your choice by pressing the [YES] or [NO] button. When a choice needs
to be confirmed the ARE YOU SURE? indicator will flash and a digitally sampled
voice will ask “Are you sure?”. Press the [YES] button to execute the specified op-
eration or the [NO] button to cancel and leave the settings or data unaffected.
If you don’t want to hear the “Are you sure?” confirmation sound, hold down the
[NO] button while initially turning the power switch on. To restore the confirmation
sound, turn the power switch off, then turn it back on again while holding down the
[YES] button. The on/off status of the confirmation sound is retained in memory
even when the power switch is turned off as long as batteries are installed on an
AC adaptor is connected.
ARE YOU SURE ?
NO YES
NOTES
• After editing a parameter other than [VOICE SELECT], the [VOICE
SELECT] parameter will automatically be re-selected after a brief
delay.
• If you attempt to change a parameter that can not be edited in the
current mode, “---” will appear on the MULTI DISPLAY.