Wegener Communications UNITY 4600 - Manual (Page 42)

U NITY 4600 U SER ’ S M ANUAL
800032-01 Rev. F 34 www.wegner.com
DTMFVOL percent
percent: Integer between 0 and 100 inclusive.
Command to set DTMF output tone levels. Immediately after entry of the command, the IRD will play out
all 16 tones (at a rate where they are individually identifiable) at the commanded level. If
percent is ‘0’,
output is essentially OFF. If percent is ‘100’, level is maximum spec level. Entering command without
parameters still plays out the tone sequence and then reports current level setting. A Local Control
Command (available from the terminal regardless of "Local Control Enable/Disable" commands from the
network).
EMAIL x
x: Either E for Enabled, or D for Disabled.
Command to enable COMPEL

printed email. A Local Control Command (available from the terminal
regardless of "Local Control Enable/Disable" commands from the network).
ERRORS type threshold
type: Either E for Error’d Seconds or C for Continuity-count errors.
threshold: Integer between 1 and 255 .
Command to set either Error’d-seconds-rate or Continuity-count Alarm threshold. Unit will show an alarm
if, over any previous 60 second interval, the number of type events which are detected exceeds threshold.
A Local Control Command (available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
EXIT
Command ends telnet sessions. Same as QUIT command.
FORCERF port
port: Either OFF or the numbers 1 , 2 , 3 , or 4 .
Command to either disable or enable effective RF switch bypassing. If port is a number, then all
subsequent carrier reception is sought at that RF feed port, regardless of the current Unit Setting. If port
is OFF , then normal RF switch function is restored. Entering the command without parameters gives
current status, either Normal RF Switch , or Forced RF Feed Port n where n is either 1 , 2 , 3 , or 4 . A Local
Control Command (available from the terminal regardless of "Local Control Enable/Disable" commands
from the network).
GHOSTLIST action PID
action: A for Add or D for Delete.
PID: Hex number between 1 and 1FFE (except 11 , reserved for SDT ).
Command to add or delete entries in the list of ghost PIDs to pass to the ASI transport output (while
Program Mapping is enabled). Entering command without the
action or pid parameter dumps the current
list.
Table 3.3: Command Directory for U4600 Terminal Commands