ZyXEL Communications M-302 - Manual (Page 20)

M-302 User’s Guide
20 Chapter 1 Getting Started
The following table describes the M-302.
The following table describes the operation of the Power (PWR) and Link (LNK) lights on
the rear of the device.
1.1.1 Application Overview
This section describes some network applications for the M-302.
1.1.1.1 Infrastructure
To connect to a network via an Access Point (AP), set the M-302 network type to
Infrastructure. Through the AP, you can access the Internet or the wired network behind the
AP.
Note: For more information on switching between Infrastructure and Ad-Hoc modes,
refer to Section 4.4 on page 44 .
Table 1 External View
LABEL DESCRIPTION
1 Removable antenna (5dBi, R-SMA connector)
2 Fixed antenna
3 Power (PWR) and Link (LNK) lights
4 PCI contacts
Table 2 Light Description
STATUS PWR LIGHT LNK LIGHT
Power off The light is off. The light is off.
Power on The light blinks slowly. The light is off.
Power on, device disabled The light is on. The light is off.
Searching for wireless network Both lights blink in series
Connected to wireless network (no traffic) Both lights blink together slowly
Connected to wireless network (traffic) Both lights blink together rapidly