ZyXEL Communications M-302 - Manual (Page 42)

M-302 User’s Guide
42 Chapter 4 ZyXEL Utility Configuration
The following table describes the labels in this screen.
4.3.1.4 IEEE 802.1x
Figure 26 Security Settings: 802.1x
The following table describes the labels in this screen.
Table 10 Security Settings: WPA-PSK
LABEL DESCRIPTION
Encryption Type The encryption mechanisms used for WPA and WPA-PSK are the same. The only
difference between the two is that WPA-PSK uses a simple common password,
instead of user-specific credentials.
Select the encryption type (TKIP or AES) for data encryption.
Refer to
Section 3.2.1.3 on page 33 for more information.
Pre-Shared Key Type a pre-shared key (same as the AP or peer device) of between 8 and 63 case-
sensitive ASCII characters (including spaces and symbols).
Back Click Back to go to the Site Survey screen to select and connect to other network.
Next Click Next to confirm your selections and advance to the Confirm Save screen.
Exit Click Exit to return to the Site Survey screen without saving.
Table 11 Security Settings: 802.1x
LABEL DESCRIPTION
Authentication
Type
The type of authentication you use depends on the authentication server or AP.
Select an authentication method from the drop down list. Options are TLS, TTLS
and PEAP.
Login Name Enter a user name.
This is the user name that you or an administrator set up on a RADIUS server.
Password This field is not available when you select TLS in the Authentication Type field.
Enter the password associated with the user name above.
Certificate This field is only available when you select TLS in the Authentication Type field.
Select a certificate used by the authentication server to authenticate the M-302.
Note: You must first have a wired connection to a network and
obtain the certificate(s) from a certificate authority (CA).