ZyXEL Communications M-302 - Manual (Page 41)

M-302 User’s Guide
Chapter 4 ZyXEL Utility Configuration 41
The following table describes the labels in this screen.
4.3.1.3 WPA-PSK
Figure 25 Security Settings: WPA-PSK
Table 9 Security Settings: WPA
LABEL DESCRIPTION
Encryption Type The encryption mechanisms used for WPA and WPA-PSK are the same. The only
difference between the two is that WPA-PSK uses a simple common password,
instead of user-specific credentials.
Select the encryption type (TKIP or AES) for data encryption.
Refer to
Section 3.2.1.3 on page 33 for more information.
Authentication
Type
Select an authentication method from the drop down list. Options are TLS, TTLS
and PEAP.
Login Name Enter a user name.
This is the user name that you or an administrator set up on a RADIUS server.
Password This field is not available when you select TLS in the Authentication Type field.
Enter the password associated with the user name above.
Certificate This field is only available when you select TLS in the Authentication Type field.
Select a certificate used by the authentication server to authenticate the M-302.
Note: You must first have a wired connection to a network and
obtain the certificate(s) from a certificate authority (CA).
Server CA Select a certificate authority (CA) that you trust and accept any certificates signed
by that CA.
Otherwise, select Trust Any to accept certificates from any CA.
PEAP Inner EAP This field is only available when you select PEAP in the Authentication Type field.
Select a PEAP protocol. Options are GTC and MS CHAP v2.
Back Click Back to go to the Site Survey screen to select and connect to other network.
Next Click Next to confirm your selections and advance to the Confirm Save screen.
Exit Click Exit to return to the Site Survey screen without saving.