Yamaha CVP-59S - Manual (Page 105)

102
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
The Utility Functions
X
Select the Song Number to be Converted
.............................
Use the SONG LCD button — or data dial or [+]/[–] buttons — to
select the song number to be converted.
C
Start the Conversion
.....................................................................................
Press the TRANSFORM LCD button to begin the conversion process.
When the conversion process is finished, the “ Completed! SONG
No. XX ” message will appear to inform you as to the SONG No. into
which the data was saved.
Z
Insert a Disk, Select the Song Copy Function, &
Select the Type of Copy Operation
...............................................
Insert the disk containing the song you want to copy, select the Song
Copy function, and use either of the first two LCD buttons to select
“
DISK1 — 1 ” to copy to a different song within the same disk, or
“ DISK1 — 2 ” to copy to a different disk.
X
Select the Source Song Number
.....................................................
Use the SONG— > LCD button to select the song you want to copy.
The data dial and [+]/[–] buttons can also be used once the SONG— > pa-
rameter has been selected. The selected song name will appear in the
upper right corner of the display.
C
Select the Destination Song (DISK 1 – 1 type copy)
..
This step is for the DISK 1 – 1 type copy only. If you have selected the DISK 1 –
2 type copy, pass this step and proceed to the next
V V V V V step.
Use the SONG button to select the song number you wish to copy to
(i.e. the destination song number). The data dial and [+]/[–] buttons can
also be used once the
SONG parameter has been selected. If you select a
song number that already contains data, that data will be overwritten by
the new song data. If the destination song already contains data, the
name of the song file will appear in the middle right corner of the dis-
play.
• The song copy function cannot be
used when the song record mode is
engaged—the “Button not valid!” alert
display will appear.
• If the Clavinova’s internal memory
contains song data, the “CVP-DISK”
copy mode will be automatically se-
lected to copy the internal memory
data to disk (see the “Copying Data
Recorded Without a Disk” below) and
the “DISK 1 – 1” or “DISK 1 – 2” copy
mode cannot be selected. In this case,
copy the internal memory data to disk
first, if you want to keep the data, and
delete the internal memory data by
using the Song Delete function (page
104). Then try the “DISK 1 – 1” or
DISK 1 – 2” copy operation again.
• Only song data recorded on the CVP-
79A/69/69A/59S and Disk Orchestra
Collection orchestra and rhythm data
can be copied using this function.
• Data cannot be copied to Disk Orches-
tra Collection disks, Disklavier disks, or
any write-protected disk.
Song Copy
Song data can be “backed up” by copying to a new song number or a different disk, as follows:
(Make sure that the song record mode is not engaged before proceeding.)