Zoom Dialer 26 - Manual (Page 19)

Frequently Asked Questions 19
The command
# * 7 1 # #
tells the dialer to listen for the first voice prompt after
the dialer dials the calling card provider’s access code.
The command
# * 8 1 # #
tells the dialer to listen for voice prompts between
subsequent numbers.
If you use these commands, the dialer will dial before
the end of the switch’s voice prompts. The advantage is
faster dialing. The disadvantages are
1.) Sensitivity to background conversations, radio, TV,
etc.
2.) The * 8 1 command may cause you to miss hearing
how much time is left on your card.
You can change back to the respective default settings
with
# * 7 0 # #
# * 8 0 # #
Q: How can I make the dialer tones quieter?
A: Please see the question above about making tones
louder.
Note that softer tones may not work as well as louder
tones in some installations. You may be able to
compensate by increasing tone length in some cases.
Please see the question above about when to make
tones longer to find out how to do this.
Q: (AutoRoute Mode) How do I bypass the dialer for a
single call?
A: If you are in AutoRoute Mode and you do not want the
dialer to route a specific call, dial *0 before the
number you want to call. For instance, if you don’t
want the dialer to route the phone number 1-212-222-
2222, take the phone off-hook and dial
*0 <wait for dialtone> 12122222222