Zebra Technologies P640I - Manual (Page 50)

980541-001 Rev. A P640i Card Printer User Guide 40
Start > Printers (or Printers and Faxes) > Right click
Zebra P640i > Properties > Device Settings > Control
>
Run Clean Cycle
Card Presence Sensor
Start > Printers (or Printers and Faxes) > Right click
Zebra P640i > Properties > Device Settings > Control
> Advanced Utilites > Show Sensor Data >
Card
Presence Sensor
[Also available through the Status screen (Device
Settings > Status >
Advanced )]
Card presence sensor values: High (around 250) = card
absent, low (around 10) = card present.
Move Carriage
Move Carriage moves the carriage to the position
specified in the drop down menu on the Advanced
Utilities window. Select a destination, then click
Move.
Start > Printers (or Printers and Faxes) > Right click
Zebra P640i > Properties > Device Settings > Control
> Advanced Utilities >
Move Carriage
Pick Position Adjust (Pixels)
Start > Printers (or Printers and Faxes) > Right click
Zebra Defects at top left and on the bottom edge were
P640i > Properties > Device Settings > Printer
Adjustment > caused by lack of support under the
card. Card Hopper >
Pick Position Adjust (Pixels)
Clean Frequency
Clean Frequency adjusts how often the card cleaning
roller is itself cleaned by contact with sticky tape in
the cleaning cassette. Acceptable values: 1 card to 20
cards; default 10 cards.
Start > Printers (or Printers and Faxes) > Right click
Zebra P640i > Properties > Device Settings > Printer
Adjustment > Cleaning Station >
Clean Frequency
Avoid These Problems
The truck platen is an important contributor to print
quality. To provide adequate support for the card, the
platen’s neoprene surface must be clean and intact.
Look for signs of delamination, especially at the edges
of the platen, and be sure to keep the surface free of
debris.
Delaminated platen
Pick Position Adjust fine tunes the extent of truck
motion relative to the home sensor located left of the
card hopper. Modify this value only if the printer has
repeated difficulty in card picking.
Dirt on platen
These image defects were caused by a “foreign
object” under the card - a tiny piece of card, less than
0.01" (0.25 mm) thick .