Zebra Technologies R2844-Z - Manual (Page 44)

ZPL II Commands for RFID
Valid programming requires that printer instructions begin with the Start
Format command (^XA) and finish with the End Format command (^XZ);
they are the opening and closing brackets, respectivley, of a label format
instruction.
This subsection describes the RFID-related commands:
■ ^WT – Write Tag
■ ^RT – Read Tag
■ ^RS – RFID Setup
■ ^RI – RFID Get Tag ID
■ ^RE – Enable/Disable Electronic Article Surveillance Bit
36 980476-001A