02r with one da-88 – Yamaha 03D User Manual
Page 33
28 02R Applications
Yamaha 02R & 03D Applications Guide
9
02R with One DA-88
This application shows how the 02R can be used with a Tascam DA-88 to create a 24-input,
8-track digital recording system. The eight digital tape returns and 24 Mic/Line inputs
provide up to 32 inputs at mixdown. In addition, the 02R’s built-in automation and scene
memory systems provide both dynamic and static mix automation referenced to timecode.
Connections
•
The Tascam (CD8-TD) card must be screwed securely in place. Do not leave the screws
out after installation as the card will not be grounded correctly.
•
The Tascam digital audio cable (PW-88DL) carries the eight tape sends and eight tape
returns.
•
The DA-88 is connected to Slot [1] of the 02R. These tape inputs correspond to tracks
one through eight.
•
The optional SY-88 Sync Board is required. The DA-88 has a dedicated timecode track
and can output SMPTE timecode or MTC. In addition, a timecode offset can be
specified on the DA-88, so the 02R automix start time can be adjusted. The DA-88 also
has the ability to re-stripe the timecode track.
•
The 75 ohm wordclock termination switch on the back of the 02R is set to ON.
02R Wordclock Setup
On the DIGITAL I/O menu, the wordclock source should be set to W.CLK.
DA-88 Wordclock Setup
The DA-88 works as wordclock master. Wordclock is fed to the 02R using a BNC to BNC
cable. The sampling rate is set when the DA-88 tape is formatted. This can be either 48 kHz
or 44.1 kHz. After formatting, the sampling rate is determined by the formatted tape.
Notes
•
The DA-88 must be powered up even when it is not being used. Failure to do so may
cause an intermittent pumping noise on the 02R.
•
On the DA-88 rear panel, set the MACHINE ID to 0.
•
The optional Tascam SY-88 Sync Board must be installed to use SMPTE timecode and
MTC. This is available from Tascam.
•
The rear panel of the SY-88 Sync Board has a DIP switch labeled MODE. Set DIP
switches 2 and 5 to ON (O). Set internal switch 8 on the SY-88 board marked S2 to ON.
•
To use the MTC function, the SY-88 firmware must be version 3.08 or higher.
•
On the Tascam (CD8-TD) card there is a DIP switch that should be set to 16-bit. This is
the initial setting, but you should confirm it. This switch is for use with Tascam High-Bit
recording applications.
•
Tascam 25-pin digital audio cables PW-88DL (5 m) and PW-88D (1 m) are available
from Tascam.