Yamaha 03D - Manual (Page 40)

02R Applications 35
Yamaha 02R & 03D Applications Guide
02R
• On the Tascam (CD8-TD) card there is a DIP switch that should be set to 16-bit. This is
the initial setting, but you should confirm it. This switch is for use with Tascam High-Bit
recording applications.
• The rear of the Cascade (CD8-CS) card has an IN/OUT switch. For 02R–A this must be
set to OUT. On 02R–B it must be set to IN.
• The optional CD8-CS kit contains two CD8-CS cards and one 25-pin straight cable.
Figure 12 Two 02Rs with Four DA-88s
DIGITAL RECORDING CONSOLE DIGITAL RECORDING CONSOLE
02R–B 02R–A
1
DA-88–D
DA-88–C
25-pin straight
cable
PW-88S 15-pin cable
SYNC IN
SYNC IN
SYNC OUT
2 1
DA-88–A
DA-88–B
PW-88S 15-pin cable
PW-88S 15-pin cable
SYNC IN
SYNC OUT
SYNC OUT
2
TDIF-1
TDIF-1
TDIF-1
TDIF-1
3 3
SMPTE timecode
or MTC Wordclock
SMPTE OUT
or MTC OUT
(phono) WC OUT
(BNC)
SMPTE
TIMECODE
INPUT
(phono) SMPTE
TIMECODE
INPUT
(phono) WORD
CLOCK
IN (BNC)
(75
Ω
=ON)
WORD
CLOCK
OUT (BNC)
WORD
CLOCK
IN (BNC)
(75
Ω
=ON)
Stereo fader, Bus
master, & Aux
master controls on
this 02R are used.
CD8-TD
CD8-TD
CD8-CS CD8-CS
Switch=OUT Switch=IN
PW-88DL 25 pin cables x2 PW-88DL 25 pin cables x2
ID=0
ID=1
ID=3
ID=2
SYNC OUT
Terminator
Optional SY-88 Sync Board installed
Rear panel DIP switches 2 and 5=O
The power amp, monitors, and
DAT recorder have been removed
from this diagram for clarity.