Yamaha CD Recordable/Rewritable Drive CRW2200S User Manual
Page 47
E-IDE (ATAPI) Connection Set Up
39
About IDE
IDE (Enhanced IDE/E-IDE) is one of the standards applied to the connection
between personal computers and their peripherals. A computer motherboard
provides two IDE connectors (primary and secondary). (Although, some
motherboards provide only a primary connector.) You may connect up to two
IDE devices (hard disk, CD-ROM, or CD-R drives) to the connectors using an
IDE cable. One of the devices connected via the IDE cable is called “master” and
the other is called “slave.”
Notes
• When you are using the IDE device as a master, connect the device to the connector of the
leading edge of the IDE cable, or you are using the device as a slave, connect the device to
the connector of the middle of the IDE cable.
• When you connect two IDE devices to one IDE cable, assign each as MASTER or SLAVE
respectively. The CRW2200E is shipped with the SLAVE setting.
Typical IDE-type hardware installation
When replacing an existing IDE-type drive to another Controller Port, you will
need to change the device settings (MASTER/SLAVE).
Note
For details on settings, refer to the documentation that came with the device or the
manufacturer’s Home Page.
Slave
Master
Slave
Master
Secondary
Motherboard
Primary