Xilinx SP601 Hardware UG518 - Manual (Page 20)

20 www.xilinx.com SP601 Hardware User Guide
UG518 (v1.1) August 19, 2009
Chapter 1: SP601 Evaluation Board
Figure 1-8 provides the UCF constraints for the SPI serial flash PROM.
References
See the Winbond Serial Flash specifications for more information at http://www.winbond-
usa.com/hq/enu/ProductAndSales/ProductLines/FlashMemory/SerialFlash/W25X64.htm .
See the XPS Serial Peripheral Interface specification for more information at
http://www.xilinx.com/support/documentation/ip_documentation/xps_spi.pdf .
4. Linear Flash BPI
An 8-bit (16 MB) Numonyx linear flash memory (TE 28F128J3D-75) (J3D type) is used to
provide non-volatile bitstream, code, and data storage. The J3D devices operate at 3.0V; the
Spartan-6 FPGA I/Os are 3.3V tolerant and provide electrically compatible logic levels to
directly access the linear flash BPI through a 2.5V bank. For details on configuring the
FPGA, see
“Configuration Options.”
X-Ref Target - Figure 1-8 NET "FPGA_D2_MISO3" LOC = "V14";
NET "SPI_CS_B" LOC = "V3";
NET "FPGA_D0_DIN_MISO_MISO1" LOC = "R13";
NET "FPGA_D1_MISO2" LOC = "T14";
NET "FPGA_MOSI_CSI_B_MISO0" LOC = "T13";
NET "FPGA_CCLK" LOC = "R15";
Figure 1-8: UCF Location Constraints for BPI Flash Connections
X-Ref Target - Figure 1-9
Figure 1-9: Linear Flash BPI Interface
Table 1-7: BPI Memory Connections
FPGA U1 Pin Schematic Netname
BPI Memory U10
Pin Number Pin
K18 FLASH_A0 32 A0
K17 FLASH_A1 28 A1
J18 FLASH_A2 27 A2
J16 FLASH_A3 26 A3
G18 FLASH_A4 25 A4
G16 FLASH_A5 24 A5
U1 U10
FPGA
BPI FLASH
INTERFACE
NUMONYX TYPE J3vD
T28F128J3D-75
ADDR, DATA, CTRL
UG518_09_070809