Zephyr AK7548ASX - Manual (Page 13)

11
PBI-1100A INTERNAL BLOWER COMPATIBLE WITH 10” ROUND VERTICAL DUCTING ONLY
Please turn to page 12 for instructions on installing CBI-xxxB in horizontal ducting mode.
1. Position blower plate over bracket on inside
back of hood and pivot up. Secure plate to hood
with (2) 10x3/16” screws. (blower pictured is a
PBI-1100A)
2. Connect male end of blower wire to female plug
in the hood. (plug is located inside the hood
behind the control panel)
3. CBI-xxxB Blower – Connect 6” round duct work
to blower collar.
PBI-110A Blower – Place 10” round adapter on
top of hood and secure with (4) M4x8 screws.
Connect 10” round duct work to 10” round
adapter.
Installation –
CBI-xxxB and PBI-1
100A
Internal Blowers