Zephyr AK7548ASX - Manual (Page 17)

15
F
The standard baffle filters are required to be cleaned frequently and as recommended in order to maintain blower
efficiency. If improperly maintained, residue from cooking will sift through filters and cause damage to hood blowers and
other sensitive components; and possibly clog duct work and create a fire hazard.
Blower On/Off
Adjust 3 Speed Levels
5 Min Delay Off
Lights On/Dim/Off
Display (Speed level, Delay Off Indicator)
1
2
3
4
5
Blower On/Off
By pressing , the blower is switched On and Off. When switched on, the blower turns on at the same
speed it was switched off at. When switched off the entire hood powers off, including the lights.
Speed Selection
The 3 speed levels are selected by pressing to decrease and to increase speed level. The
display indicates speed level selected. Pressing when the hood is off will also turn it on.
Delay Off
This is used for programmed shut down of blower and lights 5 minutes after the function is
activated. Press once, a dot displays in the lower right hand side of display indicating
the function is on. The hood will change to speed 1 and shut down after 5 minutes.
Lights On/Dim/Off
Switch lights On by pressing once, again to dim and again to switch Off.
Baffle Filter Clean Reminder
After every 30 hours of use the display will start flashing an reminding you to clean the baffle filters
from residue and possible clogs.
1
2
3
4
Display
Displays blower speed level, delay off status and filter clean/replace notification.
5
Heat Lamps On/Off
Located on the right and left side light panel are manual power on/off toggle switches. These
switches are used to turn the heat lamps on/off. Toggle between I (on) or 0 (off).
Clean Air Feature
Clean Air is a feature that turns the blower on every 4 hours for 10 minutes to remove stagnant air in
the kitchen. This feature is disabled by default and must be enabled by the user.
Features & Controls –
T
ouch Controls