ZyXEL Communications P-660H-TX - Manual (Page 26)

P-660H-Tx v2 Support Notes
(2) You have disabled FTP service in Web Configurator, Advanced setup,
Advanced -> Remote MGNT.
(3) FTP service is enabled but your host IP is not the secured host entered
in Web Configurator, Advanced setup, Advanced -> Remote MGNT.
(4) A filter set which blocks FTP from WAN is applied to WAN node. You
can check by command:
wan node index [index #]
wan node display
Log and Alert
1 . When does the P-660H-Tx v2 generate the firewall log?
The P-660H-Tx v2 generates the firewall log immediately when the packet
matches a firewall rule. The log for Default Firewall Policy (LAN to WAN, WAN
to LAN, WAN to WAN) is generated automatically with factory default setting,
but you can change it in Web Configurator.
2. What does the log show to us?
The log supports up to 128 entries. There are 5 columns for each entry. Please
see the example shown below:
3. How do I view the firewall log?
All logs generated in P-660H-Tx v2, including firewall logs, IPSec logs, system
logs are migrated to centralized logs. So you can view firewall logs in
Centralized logs: Web Configurator, Advanced setup, Maintenance -> Logs
->View Log.
The log keeps 128 entries, the new entries will overwrite the old entries when
the log has over 128 entries.
Before you can view firewall logs there are two steps you need to do:
(1) Enable log function in Centralized logs setup via either one of the following
methods,
25
All contents copyright © 2006 ZyXEL Communications Corporation.