ZyXEL Communications P-660H-TX - Manual (Page 74)

P-660H-Tx v2 Support Notes
(4) Basically the zero configuration only work on the VC that was preconigured
in the auto-haunting preconfigured table.
15. How could I configure triple play on P-660H-Tx v2?
The common triple play scenario is as follows:
0/32
Triple Play is a port-based policy to forward packets from different LAN port to
different PVCs, thus we could assign different parameters to the PVC (CBR,
UBR, VBR-RT, VBR-nRT) to guarantee different applications.
We could configure triple play on P-660H-Tx v2 via CLI. The command is:
sys tripleplay set portbase <EportID> <PVCID>
For example: sys tripleplay portbase set 1 1
sys tripleplay portbase set 2 2
sys tripleplay portbase set 3 3
The traffic from Ethernet port 1 must be forwarded to PVC1, vice versa.
The traffic from Ethernet port 2 must be forwarded to PVC2, vice versa.
The traffic from Ethernet Port3 must be forwarded to PVC3, vice versa.
16. How to configure packet filter on P-660H-Tx v2?
The P-660H-Tx v2 allows you to configure up to twelve filter sets with six rules
in each set, for a total of 72 filter rules in the system. You can apply up to four
filter sets to a particular port to block multiple types of packets. With each filter
set having up to six rules, you can have a maximum of 24 rules active for a
single port.
VOIP Server
IPTV Server
Internet
Others
Port1
Port2
Port3
Port4
ATUR IP-DSLAM VL-Switch
CPE
Access Network ISP
0/34
0/55
VOIP Telephone
Video Client
Clients surfing
Other clients
Port1 PVC1
Port2 PVC2
Port3 PVC3
Port4 PVC4
1/32
73
All contents copyright © 2006 ZyXEL Communications Corporation.