ZyXEL Communications P-660H-TX - Manual (Page 72)

P-660H-Tx v2 Support Notes
services of the line will be. After that, system will save back the correct VPI,
VCI and also services (encapsulation) type into profile of WAN interface.
• Configure the VC auto-hunting preconfigured table.
(1) Display auto-haunting preconfigured table by using command from CLI:
wan atm vchunt display
(2) Add items to the auto-haunting preconfigured table by using commands:
wan atm vchunt add <remoteNodeIndex> <vpi> <vci> <service
bit(hex)>
wan atm vchunt save
Note: <remote node> : input the remote node index 1-8
<vpi> : vpi value
<vci> : vci value
<service>: it’s a hex value, bit0:PPPoE/VC (1), bit1:PPPoE/LLC (2) ,
bit2:PPPoA/VC (4), bit3:PPPoA/LLC (8), bit4:Enet/VC (16), bit5 :Enet/LLC (32)
For example:
(1) If you need service PPPoE/LLC and Enet/LLC then the service bits will be
2+32 = 34 (decimal) = 22 (hex), you must input 22
(2) If you want to enable all service for VC hunting, the service bits will be
1+2+4+8+16+32=63(decimal)= 3f (hex), you must input 3f
Need to perform save after this by command ‘wan atm vchunt save’
71
All contents copyright © 2006 ZyXEL Communications Corporation.