ZyXEL Communications P-660H-TX - Manual (Page 40)

P-660H-Tx v2 Support Notes
Example
The following example shows how to dial to an ISP via the P-660H-Tx v2 and
then establish a tunnel to a private network. There will be three items that you
need to set up for PPTP application, these are PPTP server (WinNT), PPTP
client (Win9x) and the P-660H-Tx v2.
(1) PPTP server setup (WinNT)
• Add the VPN service from Control Panel ->Network
• Add an user account for PPTP logged on user
• Enable RAS port
• Select the network protocols from RAS such as IPX, TCP/IP NetBEUI
• Set the Internet gateway to P-660H-Tx v2
(2) PPTP client setup (Win9x)
• Add one VPN connection from Dial-Up Networking by entering the
correct username & password and the IP address of the P-660H-Tx v2's
Internet IP address for logging to NT RAS server.
• Set the Internet gateway to the router that is connecting to ISP
(3) P-660H-Tx v2 setup
• Before making a VPN connection from Win9x to WinNT server, you
need to connect P-660H-Tx v2 router to your ISP first.
• Enter the IP address of the PPTP server (WinNT server) and the
port number for PPTP as shown below:
39
All contents copyright © 2006 ZyXEL Communications Corporation.