Power saver, Timers, Feature (0 — 99) min – Xerox 6204 EN User Manual
Page 115: Printer interrupt (1 — 99 min): 1
10 Main Menu
Wide Format Copy System User Guide
109
• PRINTER INTERRUPT - Controls how long the Printer remains in the interrupted
state with no interruption at the Scan System Control Panel. This timer pertains to
print jobs that have been interrupted to allow a copy job to process. The allowed
range is 1 to 99 minutes. The factory default is 1 minute.
• FILE DELETION - Specifies the maximum amount of time a scanned image file
remains on the file system before being deleted. This timer pertains only to files
scanned when the Wide Format Copy System is in the READY TO SCAN mode. This
timer can be set between 1 and 24 hours in increments of 1 hour. When a file is
scanned in, it is given a time stamp. When the age of the file on the hard disk
exceeds the value of the FILE DELETION timer, the file is automatically deleted to
allow space for new files. The default value is 24 hours. After the files have been
deleted, the directory will also be deleted if no other files are scanned to it.
To adjust a timer:
1. Press
the
Menu
key. The MAIN MENU screen is displayed.
2. Press
the
Enter
key to select CONFIGURATION. The CONFIGURATION menu
screen is displayed.
3. Press
the
Next
key until TIMERS is highlighted.
4. Press
the
Enter
key to select TIMERS. The TIMERS screen is displayed.
TIMERS
FEATURE (0 — 99) MIN
5
PRINTER INTERRUPT (1 — 99 MIN): 1
FILE DELETION (1-24 HR): 24
Timers Screen
5. Press
the
Previous
or Next key to highlight the desired timer.
6. Press
the
Enter
key to select the highlighted timer.
7. Use the numeric keypad to enter the timer value.
8. Press
the
Enter
key to confirm the value.
9. Repeat steps 5 through 8 if you want to set the value for additional timers.
10. Press the Exit key to return to the CONFIGURATION menu screen.
Power Saver
The POWER SAVER option of the CONFIGURATION menu allows you to set the number of
hours of inactivity after which the system goes into Power Saver mode.
To adjust the power saver:
1. Press
the
Menu
key. The MAIN MENU screen is displayed.
2. Press
the
Enter
key to select CONFIGURATION. The CONFIGURATION menu
screen is displayed.
3. Press
the
Next
key until POWER SAVER is highlighted.
4. Press
the
Enter
key to select POWER SAVER. The POWER SAVER screen is
displayed.