Zanussi ZCG551 - Manual (Page 19)

Problem Possible cause Remedy
The appliance does not operate. The appliance is too hot. Cool down the appliance for some
hours
The grill, burners, ovens and timer do
not work.
There is no electrical supply. Make sure that the unit is connected
and the electrical supply is switched
on.
The grill, burners, ovens and timer do
not work.
There is no electrical supply. Examine the house electrical installa-
tion fuse.
The grill, burners, ovens and timer do
not work.
There is no gas supply. Examine the house gas supply, use
other gas appliance (Central heating
or gas fires).
Only main oven does not work. Time is not set. Set the time
There is no spark when lighting the
gas.
Burner cap and crown are placed un-
even.
Make sure that the burner cap and
crown are in correct positions.
The flame is blow out immediately af-
ter ignition.
Thermocouple is not heated suffi-
cient.
After lightning the flame, keep the
knob pushed for approximately 5
seconds.
The gas ring burns unevenly. Burner crown is blocked with food
residue.
Make sure that the injector is not
blocked and the burner crown is clear
of food particles or cleaning fluids.
Dry them with a cloth and clean stub-
born marks away with a dry nylon
brush (for example an old tooth-
brush).
The oven does not heat up. The oven is not switched on. Switch on the oven.
The oven does not heat up. The necessary settings are not set. Control the settings.
The oven does not cook evenly. Check that the appliance is correctly
installed and levelled, and that you
use the recommended temperatures
and shelf positions.
The oven lamp does not operate. The oven lamp is defective. Replace the oven lamp.
The display shows “12.00” and
"LED".
A power cut. Reset the clock.
Steam and condensation settle on the
food and in the oven cavity.
You left the dish in the oven for too
long.
Do not leave the dishes in the oven
for longer than 15-20 minutes after
the cooking process ends.
The appliance makes noises or pop-
ping sounds.
When the gas is drawn through the
burner, it can compress as they heat
up. Some metal parts of the appli-
ance expand and contract when they
heat up or cool down. The noises are
normal.
19