Zanussi ZCG551 - Manual (Page 7)

Ignition of the burner
Warning! Be very careful when you use open fire in
kitchen environment. Manufacturer decline any
responsibility in case misuse of the flame
Always light the burner before you put cookware.
To light the burner:
1. Turn the control knob counterclockwise to the maxi-
mum position ( ) and push it down.
2. Keep the control knob pushed for approximately 5
seconds; this will let thermocouple to warm up. If
not, the gas supply will be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not light, check if
the crown and its cap are in correct positions.
7
5
6
8
3
4
2
1
1
Burner cap
2 Burner crown
3
Ignition candle
4 Thermocouple
5
Slots
6 Burner body
7
Location peg
8 Hole
Replacing burner parts
1. Carefully put the burner crown on the burner body.
Do not use force.
a) Make sure that the hole in the crown is above
the ignition candle.
b) Make sure that the location pegs are in the
slots in the burner body.
c) Let the crown fall freely onto the body.
d) Make sure that you can move the crown a small
distance from side to side.
2. Put the burner cap centrally on top of the crown (en-
amel side up). Move the cap from side to side and
front to back to make sure that it is correctly instal-
led.
3. Try to light the burner. If the burner does not ignite,
adjust the crown and cap again.
Warning! Do not keep the control knob pushed for
more than 15 seconds.
If the burner does not light after 15 seconds, release the
control knob, turn it into off position and try to light the
burner again after minimum 1 minute.
If the burner accidentally goes out, turn the control
knob to the off position and try to light the burner
again after minimum 1 minute.
The spark generator can start automatically when
you switch on the mains, after installation or a pow-
er cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the symbol .
Warning! Always turn the flame down or switch it off
before you remove the pans from the burner.
Lid Safety Device
Lid has safety device, which cut off gas supply for hob. It
works only when lid is closed.
Warning! Always use the control knob to switch off
a burner. Do not use the lid as a cut-off device.
7