3Com WL-560 - Manual (Page 26)

20 C HAPTER 2: I NSTALLING THE B RIDGE
Bridge Default Settings
Table 4 shows the Bridge configuration factory defaults.
Table 4 Factory Default Settings
Property Default Setting
Device Name 3Com WWB
Device Location None (blank)
Country For U.S. version, United States and Canada
For non-U.S. version, set by the user
Client Mode Support multiple wired Ethernet clients
IP Network Setting Obtain IP address automatically
IP Address Obtained automatically (with a DHCP server)
169.254.2.2 (without a DHCP server)
Subnet Mask Obtained automatically (with a DHCP server)
255.255.0.0 (without a DHCP server)
Gateway IP Address Obtained automatically (with a DHCP server)
0.0.0.0 (without a DHCP server)
Network Mode Wireless Client (Infrastructure)
Radio Mode Auto Select
Wireless LAN Service Area Attach to any WLAN Service Area (ESSID) automatically
Channel Selection Automatic Best Channel (uses access point setting)
Transmit Power 100%
Antenna Selection Internal
Data Preamble Long (if Network Mode is set to Ad-Hoc)
Same as access point setting (if Network Mode is set
to Wireless Client [Infrastructure])
Security Setting Open System (no security)
802.1x Authentication State Disabled
SNMP Enabled
Access Control List Disabled
Administration Login Name admin
Administration Password None (blank)
TFTP Server IP Address None
FTP Server IP Address None