3Com WL-560 - Manual (Page 44)

38 C HAPTER 3: C ONFIGURING THE B RIDGE
Changing SNMP
Settings
Under System Configuration, click SNMP to display and change settings
for the Simple Network Management Protocol.
To communicate with the Bridge, the SNMP agent must first be enabled
and the Network Management Station must submit a valid community
string for authentication. Select SNMP Enable and enter data into the
fields as described below. When you are finished, click Apply.
Secondary RADIUS
Server Enter the IP address of the secondary RADIUS Authentication
Server. Make sure this address matches the address set in the
RADIUS Authentication software.
Secondary RADIUS
Port Enter the port number of the secondary RADIUS
Authentication Server. Make sure this number matches the
number set in the RADIUS Authentication software. The
default port is 1812.
Secondary RADIUS
Secret Enter the password of the secondary RADIUS Authentication
Server. Make sure this password matches the password set in
the RADIUS Authentication software.
Table 12 RADIUS Authentication Server Settings (continued)
Table 13 SNMP Settings
Setting Description
SNMP Enables or disables SNMP.
Contact Sets the location string that describes the system location.
Maximum length: 255 characters.
Community Name
(Read Only) Specifies a community string with read-only access.
Authorized management stations are able to retrieve MIB
objects. Maximum length: 23 characters.
Community Name
(Read/Write) Specifies a community string with read-write access.
Authorized management stations are able to both retrieve
and modify MIB objects. Maximum length: 23 characters.
Trap Destination
IP Address Enter the IP address of the trap manager that will receive
these messages.
Trap Destination
Community Name Enter the community name of the trap manager that will
receive these messages.