3M MP8650 - Manual (Page 19)

Figure 5-1. Remote Control
15

3M 1997 3M

Multimedia Projector MP8650
Section 5: Remote Control
5-1. How to Operate the Remote Control
The remote control keypad (Figure 5-1) controls basic projector functions. To use the remote control, aim the
remote toward the projection screen and press the desired button. The remote signal (Figure 5-3) will bounce
off of the projection screen and back to the mouse receiver and sensor on the front of the projector.
n
Note
Pressing some buttons will cause the remote
control LED to flash. This is an indication that the
current selection can be adjusted by pressing the
or buttons.
Remote Control Buttons
Press to switch between RGB1 or RGB2 input sources. Press RGB +
RESET for ON-Compressed or OFF-Windowed display mode.
Press to switch between VIDEO1 or VIDEO2 input sources. Press
VIDEO + RESET to switch displayed menu language. (Eng., Fr., Sp.)
Press to display the Volume bar. Press or to adjust speaker
volume or press RESET to return to default setting.
Press PHASE and the LED lamp will flash. Press or to
adjust screen flicker or press RESET to return to the factory default
setting.
After pressing Volume, Phase, H/V or MENU press RESET to return
these buttons to the factory default setting.
Press BLANK to display a black background with no image. Press
again to return the image to the screen.
Press to switch the audio (speaker) sound ON (volume bar turns
green) or OFF (volume bar turns red).
Press once for Memory 1, twice for Memory 2 or three times for
Memory 3. Press
SELECT
to display the picture adjustments
(brightness, contrast, P-Clock). Press or to adjust or press
RESET to go to the STANDARD default setting.
Press to select the picture adjustment setting. See
MENU
button.
Press to switch projector between projection and standby mode. In
projection mode the lamp is ON. In standby mode the lamp is OFF.
Press ZOOM and the LED will begin to flash. Press to increase
or to decrease the size of the screen image.
Press to display the focus pattern. Press to increase or to
decrease the sharpness of the screen image.
VOL
PHASE
BLANK
MUTE
MENU
SELECT
ZOOM
FOCUS