3Com ADSL Modem Ethernet - Manual (Page 39)

A
CLI C
OMMAND
D
ESCRIPTION
CLI Commands
ADD Use the ADD command to define:
■
networks you will connect to
■
SNMP communities
■
users who can telnet to the unit
Note that some parameters have default values.
add bridge
access_mac_address
<mac_address>
Adds a MAC Address to the Access MAC table. When the Access MAC feature is
enabled, only MAC Addresses in the Access MAC Table will be bridged.
add dns server
<domain_name>
primary_address [ip_address]
secondary_address [ip_address]
Adds the IP Address of a remote DNS Server for the specified Domain Name to the
Domain Name Server Table. The IP Host Name is first sent to the Primary Server to
be resolved. If that server cannot resolve the name, a request is sent to the
Secondary Server.
add filter <filter name>
Adds a filter file name to the filter table. The filter table is a managed list of filter
names used by SNMP. A filter file is a text file stored in the FLASH file system, that
you load using TFTP. Add filter also verifies the syntax of the filter file. If syntax
verification fails, you’ll receive an error message, and the filter will still be added to
the table, but is not usable. You must correct the filter file in a text editor, use
Parameters Description
<mac_address > The MAC address being granted access.
Parameters Description
<domain_name> Domain name. Use * for all domains.
primary_address The primary IP address of the DNS server.
secondary_address The secondary IP address of the DNS server.
Parameters Description
<mac_address > The MAC address being granted access.