3Com ADSL Modem Ethernet - Manual (Page 48)

A-10 A PPENDIX A: CLI C OMMAND D ESCRIPTION
list syslog Displays IP addresses which get syslog entries from the system. See add syslog for
more information, and delete syslog command to remove entries. This command
shows:
■
Syslog - IP address to which syslog entries will be sent
■
Log Level - reporting level of entries to send
■
Msg Count - current number of messages sent since system bootup
Also see list facilities and set facilities commands, which let you view and change
log reporting levels for each system facility.
list tftp clients Displays IP addresses of all users who allowed to use the Trivial File Transfer
Protocol (TFTP) to connect to the system. You must have used add network service
to add TFTP support to the system and used add tftp client to authorize users to
connect.
list users Lists all users, showing:
■
User Name - user designation you specified using add user
■
Login Service - The service used to login to the network (i.e. TELNET).
■
Status - link status: ACTIVE, INACTIVE or DISABLED
PAUSED COMMANDS
PING
ping
<ip_name_or_addr>
output [output_filename]
count [count]
interval [interval]
timeout [timeout_value]
Sends an ICMP echo request to a remote IP host. A reply from the pinged address
indicates success.
REBOOT Reboot the system. If you have made any configuration changes, be sure to save
all before rebooting. Also see the delete configuration command.
More (or CR) Continue printing
Quit Cancel rest of output
Parameters Description
<ip_name_or_address> IP address in dotted notation, or host name of remote system.
output A file name to direct output to.
count Number of ICMP echo requests to send.
interval Number of seconds to wait between sending each request.
timeout Number of seconds to wait for an echo response to return.