3Com ADSL Modem Ethernet - Manual (Page 51)

CLI Commands A-13
■
UNUSUAL - an abnormal event, which the system should recover from
■
COMMON - a regularly occurring event that is not frequent
■
VERBOSE - a regular periodic event, e.g. a routing update message
■
DEBUG - for debugging purposes only
set interface
<interface_name>
filter_access [ON | OFF]
input_filter <filter_name>
output_filter <filter_name>
Sets filter parameters for the specified protocol on the specified interface. You can
see the available filter files using list filters, view the contents of a filter file using
show filter, and add filter files to FLASH memory using TFTP.
set port <port number> pcr [number]
vci [number]
vpi [number]
description [filter_name]
input_filter [filter_name]
output_filter [filter_name]
Specifies bridge port parameters.
Parameters Description
<interface_name> Designation of interface you are setting parameters for. Limit of 32
characters.
filter_access ON causes filters specified for an interface with a set interface com mand,
to override filters specified with a set user command, when the filters are
of the same type.
input_filter Name of filter file you wish to be applied to the input stream coming in on
the specified interface. Limit: 20 characters.
output_filter Name of the filter file you wish to be applied to the output stream leaving
the specified interface. Limit: 20 characters.
Parameters Description
<port number> Port number (2..9)
input_filter Designation of the filter file in FLASH memory to be applied to the
input data stream.
output_filter Name of the filter file in FLASH memory to be applied to the out put
data stream.
Pcr Peak Cell Rate (both UBR and VBR).
Vci Virtual Channel Identifier.
Vpi Virtual Path Identifier.