3M Multimedia Projector X62w - Manual (Page 13)

13
2. Equipment connection and network setting
2.3 Manual network connection setting – In case of wired LAN - (Continued)
[About IP address]
Network address portion of PC IP address should be common with projector’s
one but the PC total IP address should not be overlapped with other networked
equipments.
For example, projector initial settings are as follows.
IP address: 192.168.1.10
Subnet mask: 255.255.255.0
Therefore, specify PC IP address as follows.
IP address: 192.168.1.xxx (xxx shows decimal number.)
Subnet mask: 255.255.255.0
Select from 1 to 254 for “xxx” not duplicating with any other equipments. In this
case, projector has “192.168.1.10” IP address, specify from 1 to 254 except 10 for
PC.
Projector IP address can be changed by using confi guration utility. (Refer to
section 2.5.)
When DHCP server exists in network, it is possible to set using IP address, which
is automatically assigned to projector.
If projector and PC exist in the same network (i.e. network address is common),
default gateway can be blank.
* DHCP is abbreviation for “Dynamic Host Confi guration Protocol” and the function
to provide necessary setting for network like IP address from server to client.
Server that has DHCP function is called DHCP server.
* When projector and PC exist in different networks, default gateway setting is
necessary. Contact network administrator in detail.