3M Multimedia Projector X62w - Manual (Page 72)

72
Date/Time Settings ( 34)
The Date/Time setting can be adjusted via a web browser.
Example: If the IP address of the projector is set to 192.168.1.10/:
• A Network Restart is required after the Daylight Savings Time or
SNTP confi guration settings have been changed.
• The battery for the built in clock may be dead if the clock loses time even
when the DATE and TIME have been set correctly. Replace the battery by
following the instructions on replacing the battery.
(
Internal clock battery of the Operator's Guide)
• The Internal Clock’s time may not remain accurate. Using SNTP is
recommended to maintain accurate time.
NOTE
1) Enter [http://192.168.1.10] into the address bar of the web browser.
Enter the Administrator ID and Password and click [Logon] .
2) Click [Date/Time Settings] on the main menu and confi gure each item.
Refer to the [Date/Time Settings] item in [Confi guring and Controlling the
Projector via a Web Browser]
for further information.
3) Click the [Apply] button to save the settings.
4. Utilize projector – Advanced -