Garmin GNS 530 - Manual (Page 109)

GNS 530(A) Pilot’s Guide and Reference 190-00181-00 Rev. H
SECTION 6
PROCEDURES
6-27
1) Select Flagstaff Pulliam (KFLG) as the
destination, using the Direct-to Key or as
the last waypoint in a flight plan.
2) Press the PROC (Figure 6-63) Key and select
the ‘ILS 21’ approach using the steps outlined
in Section 6.1.
Figure 6-63 Procedures Page
3) From the Transitions Window, select ‘SHUTR’
as the IAF (Figure 6-64). Also, select ‘Load?’
(or ‘Activate?’, if already cleared for the
approach).
Figure 6-64 Transitions Window
4) A reminder message appears, indicating that
GPS can only be used for approach monitoring.
As mentioned, the VLOC receiver must be
used for this approach. Press the ENT Key to
acknowledge the message.
When an ILS approach is loaded or activated, the ILS
frequency is automatically placed in the standby field of
the VLOC Window. To use this frequency, press the VLOC
Flip-flop Key to place it in the active frequency field.