Garmin GNS 530 - Manual (Page 187)

GNS 530(A) Pilot’s Guide and Reference 190-00181-00 Rev. H 10-27
SECTION 10
AUX PAGES
Setup Page: Display Backlight
Changing the backlighting intensity:
1) Select ‘Display Backlight’ from the Setup Page,
using the steps described at the beginning of
this section.
2) The flashing cursor highlights the backlight
mode field. Turn the small right knob to
select the desired mode: Auto or Manual
(Figure 10-41). Press the ENT Key to accept
the selection.
Figure 10-41 Backlight Mode Window
3) If ‘Manual’ is selected, the flashing cursor
moves to the backlight level field. Turn the
small right knob to select the desired level.
Press the ENT Key to accept the selection.
Setup Page: Nearest Airport Criteria
Setting the minimum runway length and
runway surface:
1) Select ‘Nearest Airport Criteria’ from the
Setup Page, using the steps described at the
beginning of this section.
2) The flashing cursor highlights the runway
surface field (Figure 10-42). Turn the small
right knob to select the desired surface. The
following options are available:
• Any surface
• Hard surfaces only
• Hard or Soft surfaces
• Water landings only
Figure 10-42 Surface Type Window
3) Press the ENT Key to accept the runway surface
selection.
4) The flashing cursor moves to the minimum
runway length field. To enter a different
minimum runway length, use the small and
large right knobs to enter the desired length.
Press the ENT Key when finished.