RIDGID SeeSnake DVDPak - Manual (Page 8)

• Flammable liquids, vapors or dust that may ignite.
If present, do not work in area until sources have
been identified and corrected. The DVD
Pak
is not
explosion proof. Electrical connections can cause
sparks.
• Clear, level, stable dry place for operator. Do not use
the machine while standing in water.
• Clear path to electrical outlet, that does not contain
any potential sources of damage for the power
cord, when using external power.
2. Inspect the work to be done If possible, determine the
drain access point(s), size(s) and length(s), pres-
ence of drain cleaning chemicals or other chemi-
cals, etc. If chemicals are present, it is important to
understand the specific safety measures required to
work around those chemicals. Contact the chemi-
cal manufacturer for required information.
3. Determine the correct equipment for the application.
The SeeSnake DVD
Pak
is made to is made to view
and record inspections done with an inspection cam-
era. Inspection equipment for other applications can
be found by consulting the Ridge Tool Catalog, online
at www.RIDGID.com or www.RIDGID.eu.
4. Make sure all equipment has been properly inspected.
5. Evaluate the work area and determine if any barriers
are needed to keep bystanders away. Bystanders can
distract the operator during use. If working near traf-
fic, erect cones or other barriers to alert drivers.
6. If needed, remove fixture (water closet, sink, etc.)
to allow access.
DVDPak Placement
Open the DVD
Pak
sunshade and display and place it to
allow easy access and viewing while manipulating the
camera and pushrod for an inspection. Make sure that the
location is not wet and will not let the DVD
Pak
and other
equipment get wet during use. The DVD
Pak
is not water
resistant and exposure to wet conditions can cause elec-
trical shock or equipment damage.
Place camera and reel as instructed in their Operatorʼs
Manual. Ensure the DVD
Pak
and cable reel are stable.
Pre-Operation Inspection
WARNING
Before each use, inspect your SeeSnake DVDPak
and correct any problems to reduce the risk of se-
rious injury from electrical shock or other causes
and prevent machine damage.
1. Confirm that the power is off, any external power
and cords are disconnected, and the battery is re-
moved. Inspect the cords, cables and connectors
for damage or modification.
2. Clean any dirt, oil or other contamination from the
SeeSnake DVD
Pak
to aid in inspection and to prevent
the unit from slipping from your grip while transporting
or using.
3. Inspect the DVD
Pak
for any broken, worn, missing,
misaligned or binding parts, or any other condition
which might prevent safe, normal operation.
4. Inspect any other equipment being used per its in-
structions to make sure it is in good usable condition.
5. If any problems are found, do not use the unit until the
problems are corrected.
Work Area and Equipment
Set Up
WARNING
Set up the DVDPak and work area according to
these procedures to reduce the risk of injury from
electrical shock, fire, and other causes, and to pre-
vent damage to the DVDPak.
1. Check work area for:
• Adequate lighting.
Ridge Tool Company 6
SeeSnake ® DVDPak