STIEBEL ELTRON psh 30 trend - Manual (Page 17)

oPerATion
Safety
En
gl
ish
www.stiebel-eltron.com PSH Trend | 17
1.2 other symbols in this documentation
Note
General information is identified by the symbol shown
on the left.
f f Read these texts carefully.
Symbol Meaning
Material losses
(appliance and consequential losses, environmental pol-
lution)
Appliance disposal
f f This symbol indicates that you have to do something. The ac-
tion you need to take is described step by step.
1.3 units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
2. safety
2.1 intended use
The appliance is intended for heating domestic hot water and can
supply one or more draw-off points.
This appliance is intended for domestic use. It can be used safely
by untrained persons. The appliance can also be used in a non-do-
mestic environment, e.g. in a small business, as long as it is used
in the same way.
Any other use beyond that described shall be deemed inappro-
priate. Using the appliance for heating fluids other than water or
water supplemented with chemicals, such as brine, is also deemed
inappropriate.
Observation of these instructions and of instructions for any ac-
cessories used is also part of the correct use of this appliance.
2.2 general safety instructions
WARNING Burns
During operation, the tap and safety valve can reach
temperatures in excess of 60 °C.
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
!
WARNING Injury
The appliance may be used by children aged 8 and up and
persons with reduced physical, sensory or mental capa-
bilities or a lack of experience and know-how provided
that they are supervised or they have been instructed
on how to use the appliance safely and have understood
the resulting risks. Children must never play with the
appliance. Children must never clean the appliance or
perform user maintenance unless they are supervised.
!
Material losses
The user should protect the water lines and the safety
valve from frost.
Note
The appliance is under pressure. During the heat-up
process, expansion water will drip from the safety valve.
f f If water continues to drip when heating is complet-
ed, please inform your qualified contractor.
2.3 ce designation
The CE designation shows that the appliance meets all essential
requirements according to the:
- Electromagnetic Compatibility Directive
- Low Voltage Directive
2.4 test symbols
See type plate on the appliance.
3. appliance description
The closed (pressure-tested) appliance heats DHW electrically.
You can adjust the temperature using the temperature selector.
Subject to the power supply, the water is heated automatically to
the required temperature.
The internal steel cylinder is coated with special "Co Pro" enamel
and is equipped with a protective anode. The anode protects the
internal cylinder from corrosion.
Frost protection
The appliance is also protected against frost by the temperature
setting "*", provided that the power supply is guaranteed. The
appliance switches on in good time and heats the water. The ap-
pliance does not protect the water supply lines and the safety
valve from frost.
!