FIAT Croma User Manual

Page 137

Advertising
background image

When stopping the car with a gear high-
er than 1st gear, transmission will set au-
tomatically at 1st gear.

When stopping the car under poor grip
conditions (snow, ice), at next starting the
transmission control unit could engage a
gear higher than 1st gear to prevent wheel
slipping. This shall not be considered as a
fault

IMPORTANT: in the event of excessive
oil temperatures (see section “Warning
lights and messages”), the electronic con-
trol intervenes excluding sequential mode
and activating automatic mode in order to
safeguard transmission life. Sequential
mode will be resumed as soon as regular
operating temperatures are restored.

AUTOMATIC MODE

D can be selected from sequential mode
under whatever driving condition.

When passing from sequential mode to D,
the gear to engage is selected by trans-
mission control unit according to engine
rpm and speed (accelerator pedal posi-
tion).

Low engine power demand will result in
long gears engagement and reduced fuel
consumption. Increasing speed by press-
ing the accelerator will automatically en-
gage short gears that will result in im-
proved performance as to pickup and ac-
celeration: in this case fuel consumption
will increase.

For speedy pickup:
❒ press the accelerator pedal flat-out,

the kick-down device will cut in to ob-
tain max. performance in terms of
pickup and acceleration. In this case fu-
el consumption will obviously increase.

IMPORTANT When driving under poor
grip conditions (snow, ice, etc.) avoid to
engage the kick-down device.

SEQUENTIAL MODE

In sequential mode, the electronic auto-
matic transmission works like a fixed gear
sequential gearbox.

From position D move the gear lever left-
wards:
❒ move gear lever to +: to upshift;
❒ move gear lever to –: to downshift.
Gears are displayed by digits on the in-
strument panel. Non-stop monitoring car-
ried out by transmission control unit ex-
cludes whatever possibility of error.

Downshifting (or upshifting) is only pos-
sible if engine rpm enables it.

In sequential mode, electronic transmis-
sion control can however intervene in self-
adapting mode by shifting gears automat-
ically when engine rpm exceeds or falls be-
low the admitted rpm limit.

136

W

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

CAR

MAINTENANCE

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

SAFETY DEVICES

CORRECT USE OF THE CAR

127-144 Croma TRW GB 28-09-2007 11:21 Pagina 136

Advertising