HONDA 2013 Ridgeline - Manual (Page 352)

Never use a puncture-repairing agent
in a flat tire. If used, you will have to
replace the tire pressure sensor.
Have the flat tire repaired by your
dealer as soon as possible.
The following chart shows the
recommended cold tire pressures
for most normal and high-speed
driving conditions.
Your tires have wear indicators
molded into the tread. When the
tread wears down, you will see a 1/2
inch (12.7 mm) wide band across the
tread. This shows there is less than
1/16 inch (1.6 mm) of tread left on
the tire.
A tire this worn gives very little
traction on wet roads. You should
replace the tire if you can see three
or more tread wear indicators.
The compact spare tire pressure is:
Excessive tread wear.
Cuts, splits, or cracks in the side
of the tire. Replace the tire if you
can see fabric or cord.
Bumps or bulges in the tread or
side of the tire. Replace the tire if
you find either of these conditions.
Every time you check inflation, you
should also examine the tires for
damage, foreign objects, and wear.
You should look for:
For additional information about
your tires, see page
.
For convenience, the recommended
tire sizes and cold tire pressures are
on a label on the driver’s doorjamb.
390
Tire Size Cold Tire Pressure
Tire Size Cold Tire Pressure
Front/Rear:
Front/Rear:
RTL, Touring, and Sport models
RT, RTS, DX, and VP models
Recommended Tire Pressures
Tire Inspection
Tires
347
INDICATOR LOCATION MARKS
TREAD WEAR INDICATORS
60 psi (420 kPa , 4.2 kgf/cm )
P245/65R17 105T 32 psi (220 kPa ,
2.2 kgf/cm )
P245/60R18 104T 32 psi (220 kPa ,
2.2 kgf/cm )
12/08/09 16:45:08 31SJC670_354
2013 Ridgeline
Ma
int
e
na
nce